Our HappyVinyl Deluxe is a must for everyone who loves decoration! You can beautify vases, pictures, walls, decorative objects, cupboards, mirrors and so much more with them!

There is the right foil for every style of living, whether gold, silver, copper, or even rose gold ... brushed and shiny. Or the rainbow foil with its great shimmer in rainbow colors

You get HappyVinyl Deluxe in DinA4 and by the meter and in 9 different colors.

It is only suitable for indoor use. 

Silhouette cut settings (new knife):

• Speed: 5 - depending on the motif
• Contact pressure: 16
• Knife: 2

Brother cut settings (new knife):

• Speed: 3, depending on the subject
• Contact pressure: -2
• Knife: 2

It is always advisable to make a test cut. Especially if the knife is a bit older, the knife setting, thickness or speed may have to be adjusted.
The settings for the knife are or are defined once in the program and must then be changed or set on the knife holder itself.
Not all films are the same, even if they are of the same type, so the cutting results can be slightly different with the same settings for different colors.

Suitable for:  wall decoration / interior decoration

1. Create the design in Silhouette software or Brother CanvasWorkspace.
Place the HappyVinyl Deluxe in the plotter with the colored side facing upwards, so that the white support points downwards.
(With the HappyVinyl Deluxe the motif does not have to be mirrored)

2. The surface on which the HappyVinyl Deluxe is to be applied must be cleaned / degreased before application.

3. After weeding , the transfer film is glued firmly to the top of the HappyVinyl Deluxe with the help of the HappySqueegee . After that is done, the carrier film of the HappyVinyl Deluxe can be removed. At the end you have the transfer film with the motif.

Before using the  HappyMask  , the adhesive strength of the transfer film should be tested in an inconspicuous place on the surface to be glued .

4. Now that everything is ready, the design can be applied to the substrate. Glue the design
on the surface at a corner and apply the design piece by piece to the surface with the help of the HappySqueegee . The design is smoothed with the HappySqueegee  and any air bubbles are smoothed out under the film.
After everything is firmly glued to the surface, the HappyMask is carefully removed flat again.
The HappyMask can be used more often as long as it remains adhesive.

5. A very personal interior design is ready.